You will love this easy to do project for Halloween Treats.
Here is the recipe
Cast-A-Spell Designer Series Paper
Whisper White Paper
Elegant Eggplant Classic Ink
Perfect Plum Classic Ink
Green Galore Classic Ink
1 3/4 inch circle punch
Hole Punch
1/4 inch grosgrain pumpkin pie ribbon – cut at approximately 15 inches long
Craft and Paper Scissors
Sweet Centers Stamp Set
Sweet Treat Cups
Snail Adhesive
Candy of your choice
Sweet Centers Stamp Set page 6 Holiday Mini Catalog, Item number 116521 $29.95
You can stamp your images on 3 x 3 inch squares or on a full sheet and then trim. I prefer to trim them because if I stamp crooked I don't have to re do it! 🙂
Trimming Stamped Image
Get your 1 3/4 inch punch out and then flip it over and insert the stamped image inside it and then line it up so you can punch out the middle.
Punch out the center and set aside. Now get your Cast a Spell Designer Series Double Sided paper.
Now trim to approximately 3 inch x 3 inch square. It's actually a little smaller than that so if you don't want to waste paper a little over 2 3/4 inch square. After you cut out the Designer Series Paper, then trim with Craft and Paper Scissors.
Now take your punched out square and put adhesive on it, pay close attention to the corners.
Get your Sweet Treat Cup and insert into hole.
Now peel off the backing of the sweet treat cup.
Now get the candy you bought to put inside. I found that you can put between 7-8 candy corn inside each treat cup, or 1 mini box of nerds.
Pour the candy in.
Now your ready for the Cast-A-Spell designer series paper to go on the back. I LOVE using the designer paper on this because you can see the design between the candy and make it very festive!
Carefully line up the edges and it makes for easier trimming! 
Put adhesive on your Metal Circle Tag and then put the punched out image inside! 
Now get your Pumpkin Pie 1/4 grosgrain ribbon and punch a hole with the hole punch in the upper right hand corder and the Metal Circle, feed ribbon through.
Now tie a bow and trim the ribbon and your done!
I did three of these treats and some I did with different candy and without the metal tag. The possibilities are endless with this fun project! ENJOY!!!
.
